Chanzon 12V 5A LED Strip Power Supply 60W AC DC Adapter UL Listed for CCTV 2.1x5.5 2.5x5.5 Plug (Input 110V-220V, Output 12 Volt 5 Amp 60 Watt) Converter LED Driver Lighting Transformer 12 V 5 A

8 reviews for Chanzon 12V 5A LED Strip Power Supply 60W AC DC Adapter UL Listed for CCTV 2.1×5.5 2.5×5.5 Plug (Input 110V-220V, Output 12 Volt 5 Amp 60 Watt) Converter LED Driver Lighting Transformer 12 V 5 A

1. 

   Rated 5 out of 5

   Larry Rowthorn – September 8, 2023

   
   I purchased one of these and then another 25 back in April of 2018 to replace ones used on some medical monitors that were failing and the OEM units were no longer available. Just needed 12V 5A with the correct size plug and these fit the bill. They turned out to be very dependable and eventually outlasted the monitors. No failures over the past five years. Very happy.

2. 

   Rated 5 out of 5

   Dave S – September 4, 2023

   
   Steady and consistent

3. 

   Rated 5 out of 5

   tommcg – February 22, 2023

   
   This is my third 12V 5A power supply, hopefully third time is a charm.While this unit was more expensive than other 12V 5A adapters, it claimed efficiency level “Class VI”, so I decided to try it after another brand 12V 5A unit abruptly failed.I measured output voltage at various current loads using digital electronic load tester, powering the adapter with 123VAC and letting the unit warm up for 30 minutes at midrange load. The output voltages were measured at the output of the DC connector.The voltage output starts at 12.34V with zero load and slowly tapers (almost linear) to 11.965V at 5.0A of output (max rated), and still provides 11.827V at 6.5A of output, 30% beyond rated capacity. I would not recommend running it beyond 5A continuous, but nice to have some headroom for intermittent higher loads. The overload protection kicked in above 6.75A output, dropping output voltage to zero until load reduced.Measuring wattage draw at the wall socket to compute efficiency shows peak efficiency at 89% between 0.5A and 1.0A of output, 87% at 3.0A, and 85.5% efficiency at 5.0A output. That is significantly better than any other 5A adapters I’ve tested. Also noteworthy that at zero load, there is nearly zero wattage draw from the wall, unlike other adapters I’ve tested that have half a watt or more of phantom power draw at zero output, so the “Class VI” efficiency label seems legit.

   
4. 

   Rated 5 out of 5

   Ricky M Purvis – July 16, 2023

   
   My tivo was not fully booting. Stuck on the boot screen. This power supply fixed my problem.

5. 

   Rated 5 out of 5

   DRockstar – May 18, 2019

   
   I am reviewing the following product: Chanzon 12V 5A 60W AC DC Power Supply Adapter (Input 110V-220V, Output 12 Volt 5 Amp 60 Watt)This power supply was an extremely important purchase for me. I bought it since it was highest rated power supply on Amazon.com with the requirements I was looking for. I wanted a genuine 12V 5A Positive tip power supply that could provide up to 1A each to up to 5 items simultaneously. I’m using this with a Pig Hog 10 Spot power splitter to power four semimodular synthesizers at the same time. I needed this power supply to have enough current to do the job, without introducing noise into any of the circuits, since I am cross patching audio and control voltage across several synths in my musical endeavors. I’m currently using this to power the following at the same time: Arturia MicroBrute, Moog Mother 32, Behringer Model D, and Behringer Neutron. This power supply had to have the advertised current rating, since I wanted the power supply to be well beyond the current specs for what I am powering. I did not want to overwork the power supply by shortchanging the current draw.I have been using this Chanzon Power Supply for over 2 months now, with no issues whatsoever so far. I was very careful testing with each and every synth before relying on this full time. I have had no issues with noise. The power supply gets warm, without becoming hot. I have left it on for days at a time without issue. I have this plugged into a Furman power conditioner that I switch on to power all my current synths simultaneously. This has enabled me to replace 4 DC wall wart power supplies that took up a lot of space. I am grateful the positive reviews on this power supply have been genuine, since my setup is quite expensive and quite a labor of love.I want to leave this review to help any others that endeavor to simplify their power to their semimodular synthesizers. Before you attempt to do this, be informed about your power requirements, voltage, and tip polarity. Getting any of that wrong can destroy your precious gear. But I am writing this to confirm that this power supply has worked flawlessly for me and what I wanted to achieve, and I’m grateful for it. I would recommend this to power any of the synths I have tested it with. I could be used to power just one of them, or all of them at the same time, as long as you have a quality splitter.Here are Amazon.com links to my setup in case it helps anyone else:https://www.amazon.com/110V-220V-Converter-Lighting-Transformer-Flexible/dp/B073QTNF9F (this product I’m reviewing)https://www.amazon.com/Pig-Power-Spot-Daisy-Chain/dp/B013M8CKMWhttps://www.amazon.com/Arturia-MicroBrute-Analog-Synthesizer/dp/B00G31YMVShttps://www.amazon.com/Moog-Mother-32-Modular-Analog-Synthesizer/dp/B0161LXW06https://www.amazon.com/Behringer-MODELD-Synthesizer/dp/B07BHYZRYGhttps://www.amazon.com/Behringer-NEUTRON-BEH-Synthesizer/dp/B07J1VP47VPeace, and may your experience with this be as positive as mine is. I should buy more just to have backup.

6. 

   Rated 5 out of 5

   Sha – June 1, 2023

   
   This Chanzon 12V 5A AC DC Power Supply Adapter replaced the AC adapter that originally came with my TIVO Roamio OTA DVR. That original adapter was Tivo R3413 AC adapter output 12V 2.0 Amp.One day my TIVO Roamio stopped working. It had continuously blinking red/blue/green LED lights. I read that replacing power adapter would fix it. Online post recommended this Chanzon adapter. Although the Chanzon adapter is rated for 5 amps, it meets power requirements of TIVO Roamio.

7. 

   Rated 5 out of 5

   UTA – February 4, 2023

   
   We use the Chanzon to power an APC CP12142LI. The power supply that APC recommends is 12V 3A, even though the APC accepts more amps. The 12V 5A Chanzon charged the APC in less than one day, while the 12V 3A charger appeared to be taking over two weeks to charge the APC. The Chanzon is UL listed, which is a big plus. The Chanzon apparently has bigger capacitors than many 12V 5A chargers, which increases the start-up time and the time that a voltage output remains after disconnect. For most applications, the bigger capacitors provide a smoother output, but the longer start-up time could be distracting for some applications like turning lights and off. For our application, the longer start-up time is no problem whatsoever and we prefer the higher quality output waveform.

8. 

   Rated 5 out of 5

   Christian Turpin – November 26, 2018

   .
   👍